WS-9046U Wireless 433 MHz Radio-controlled Weather Station Instruction Manual
9These icons indicate the expected weather change in the next 12 to 24 hours. The icon does not give an exact prediction of the weather, however it
102. Press and hold the SET button for 5 seconds. 3. The record is now reset and will show the current time in the TIME LCD and current indoor temp
114. The WIND SPEED LCD will now show the maximum wind gust. 5. Press and release the WIND/RAIN/SNZ button. 6. The WIND SPEED LCD will now show th
12spray. 7 32-38 mph 50-61 kph 28-33 knots Moderate or Near Gale Large trees sway, becoming difficult to walk. Larger waves develop, white foam from
13Rainfall volume reading Rainfall volume unit ` To view the current rainfall measurements: Press and release the WIND
14Note: When in the 12-hour mode and setting an alarm for a time between noon and midnight, “PM” will appear to the left of the alarm time in the DA
15 II. THE REMOTE WIND SPEED SENSOR The remote wind speed sensor can be mounted two ways: • With the use of screws • Using nylon straps • Using th
16III. THE INDOOR WEATHER STATION 1) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from th
17SPECIFICATIONS Weather data measuring range: Indoor: 14.2°F to 139.8°F with 0.2°F resolution (0°C to 59.9°C with 0.1°C resolution) “OFL” displayed
18inability to receive a signal due to any source of interference.. This warranty covers only actual defects within the product itself, and does not
1TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 2-3 About WWVB 3 Quick Set-Up Guide 3 Detailed Set-Up Guide Battery insta
2Date LCD INVENTORY OF CONTENTS 1. The WS-9046U weather station (Figure 1). 2. One TX8U remote temperature/humidity sensor (Figure 2). 3. One T
3ADDITIONAL EQUIPMENT (not included) 1. Three fresh AA 1.5V batteries for the indoor weather station. 2. Two fresh AA 1.5V batteries for the remote
4 DETAILED SET-UP GUIDE BATTERY INSTALLATION The first step to powering up the weather station is to insert the connector (RJ11) at the end of the
5SET key IN/HR key WIND/RAIN/ SNZ key OUT/MIN key ALM/+ key II. FUNCTION KEYS The function keys are located on the front of the unit directly below
6 Note: “DST OFF” indicates that the feature is off and the WWVB will not change times automatically. “DST ON” indicates that the feature is on and
7Note: Reception of the WWVB signal will also set the date and day. The reception of the signal will override any programmed date and day. 1. Pres
84. Either “1”, “2” or “3” will flash in the TIME LCD and the forecast icon and tendency arrows will flash in the FORECAST LCD. 5. Press and releas
Comments to this Manuals