La Crosse Technology WS-9021U User Manual

0Contents Language Page _______________________________________________________________ English French Spanish

9 • *When the signal is successfully received by the Temperature Station, the icon will be switched on. (If not successful, the icon will not be sh

10TIME SETTING 1. After exiting the 12/24 Hour Setting, the hour will begin flashing in the time display. 2. Press and release the min/max/+ button

113. Press and release the min/max/+ button once more to return to the current temperatures. RESETTING THE MINIMUM AND MAXIMUM READINGS: User may r

12LCD will light up briefly. Following the indoor temperature and the time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds,

13successfully received. If this is not happen, user shall restart the setting up from step 1. NOTE: You must insert the batteries into the third s

14MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the temperature sensor on a

15½ reduction typical of most obstructions. It is possible to receive a signal through these materials, however maximum range will be much less due

16To wall mount: 1. Remove the mounting bracket from the temperature sensor. 2. Mount using either screws or adhesive tape. 3. Reattach the temper

172. To wall mount, push the table stand flat against the Wireless Temperature Station (if it isn’t already flat). Fix a screw (not included) into

184) Using good quality alkaline batteries, place the batteries back into the outdoor temperature sensor; making sure they are installed according t

1TABLE OF CONTENTS Topic Page INVENTORY OF CONTENTS QUICK SETUP DETAILED SETUP GUIDE BATTERY INSTALLATION 12 OR 24 HOUR TIME DISPLAY TIME S

19 SPECIFICATIONS Transmitting Frequency 915 MHz TEMPERATURE MEASURING RANGES Indoor 14.1°F to 139.8°F with 0.2°F resolution. Outdoor -39.8 °F to 1

20DIMENSION: (H x W x D) Receiver 2.76 x 1.14 x 4.54 in (70 x 29 x 115.2 mm) Temperature Sensor 1.50 x 0.83 x 5.05 in (38.2 x 21.2 x 128.3 mm) B

21purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace t

22presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow ins

23This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of co

24 Question? Instructions? Please visit: www.lacrossetechnology.com/9021 All rights reserved. This handbook must not be reproduced in any form, eve

2 This product offers: INSTANT TRANSMISSIONis the state-of-the-art new wireless transmission technology, exclusively designed an

3 FIGURE 1Low Battery IndicatorMax icon 12 or 24 HourTime DisplaySet/ChannelButtonMinimum/Maximum & Plus Button Outdoor Tem

4Figure 2INVENTORY OF CONTENTS 1. Wireless Temperature Station (Figure 1) 2. Wireless Temperature Sensor (TX29) and mounting bracket. (Figure 2) 3.

5QUICK SETUP Hint: Use good quality Alkaline Batteries; avoid rechargeable batteries. 1. Have the Wireless Temperature Station and temperature sens

6NOTE: Fog and mist will not harm your temperature sensor, but direct rain must be avoided. DETAILED SETUP GUIDE BATTERY INSTALLATION - When one

7 TEMPERATURE SENSOR 1. Remove the Battery Cover. 2. Observing the correct polarity, install 2 “AA” Alkaline Batteries—make sure they do not spring

81. Remove the Battery Cover on the back of the Wireless Temperature Station. 2. Observing the correct polarity, install 2 “AA” Alkaline Batteries.