WS-7159U Wireless 433 MHz Radio-controlled Weather Station Instruction Manual
10may manually set the time or leave the time function alone (reception will occur regardless). B. MANUAL TIME SETTING Note: When in the 12-hour f
1110. Press and release the SET button to confirm and advance to the snooze setting. X. SETTING THE SNOOZE Note: This is an unused function of th
124. Either “1”, “2” or “3” will flash in the time LCD. 5. Press and release the IN button to select the forecast sensitivity 6. Press a
13another floor). In areas where the weather is not largely affected by the change of air pressure, the sensitivity setting should be set to 1. A.
14is expected to become worse or remain poor. No arrow means the pressure is stable. II. INDOOR TEMPERATURE, HUMIDITY, AND COMFORT LEVEL INDICATOR
152. Press the IN button again (once while “MIN” is still displayed, twice otherwise). “MAX” appears above the indoor temperature and the LCD will f
16V. ADDING REMOTE TEMPERATURE SENSORS (OPTIONAL) The WS-7159U is able to receive signals from 3 different remote temperature sensors. The remote t
172. To view the Minimum/Maximum temperature: first select which remote temperature sensor to read data from (indicated by the “boxed” number), then
182) Place the mounting bracket over the desired location. 3) Through the three screw holes of the bracket, mark the mounting surface with a pencil
192) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. 3) Place the indoor weathe
2TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery install
20because of the shielding effect of the display's case. In addition, the case can act as a heat sink to absorb and store heat from external sou
21Transmission Range: 330 feet (in open space). Power Supply: Weather Station: 2 x AA, IEC LR6, 1.5V. Temperature Transmitter: 2 x AA, IEC LR3, 1.
22This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of co
3INVENTORY OF CONTENTS 1. The indoor weather station (Figure 1). 2. One remote temperature sensor with mounting bracket (Figure 2). 3. Three eac
4QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor weather station and remote temper
5 A. REMOTE TEMPERATURE SENSOR 1. Remove the mounting bracket. The bracket snaps on and off easily. 2. Remove the battery cover, by sliding t
6time-date readings. If you don’t leave the program mode during the programming of sections IV through XI, you can advance to step 4 of the next prog
7 Note: There are 8 LCD contrast levels to choose from—“Lcd 0” is the lightest, and “Lcd 7” is the darkest. 3. Press and release the IN button to
8HAW; Hawaii -10 6. Press and release the SET button to confirm and advance to the Daylight Saving Time setting. V. DAYLIGHT SAVING TIME (DST) SE
9VII. 12 OR 24 HOUR TIME SETTING 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the time LCD and the number setting will f
Comments to this Manuals