La Crosse Technology Clock WS8157U User Manual download pdf (Page 15)

POSITIONING THE RADIO-CONTROLLED CLOCK:

There are two possible ways to mount the radio-controlled clock:

• use of the foldout table stand, or

• wall mounting

FOLDOUT TABLE STAND

The foldout table stand leg is located on the backside. Pull the stand out from

the bottom center edge of the radio-controlled clock, below the battery

compartment. Once the foldout table stand is extended, place the radio-

controlled clock in an appropriate location.

WALL MOUNTING

1) Using a straightedge, horizontally space at 2-3/4 of an inch (70 mm)

three screw positions on a wall.

2) Install three mounting screws (not included) into a wall within

transmission range—leaving approximately 3/16 of an inch (5mm)

extended from the wall.

3) Place the radio-controlled clock onto the screws, using the hanging

holes on the backside. Gently pull the radio-controlled clock down to

lock the screws into place.

Note:

Always ensure that the radio-controlled clock locks onto the screws before

releasing.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

No comments

La Crosse Technology Clock WS8157U User Manual Page 15