La-crosse-technology WS-9016U User Manual

WS-9016U Wireless 433 MHz Radio-controlled Sun/Moon Weather Station Instruction Manual

10LCD Contrast Setting The LCD contrast can be set within 8 levels, from LCD 0 to LCD7 (the default setting is LCD 5): 1. Press and hold the

11Flashing Time Zone Setting The default (factory set) time zone of the indoor weather station is EST –5 (the default time zone for the default

12Digits flashing Tower icon flashing Flashing WWVB ON/OFF Setting In areas where reception of the WWVB time is not possible the WWVB time recept

13Manual Time Setting In case the indoor weather station cannot detect the WWVB signal (for example due to disturbances, transmitting distance, etc.

14Calendar Setting The default (factory set) date of the indoor weather station is 1. 1. in the year 2001. Once the radio-controlled time s

15Digit flashingSnooze Setting The snooze time can be set from OFF to a maximum time of 30 minutes. The default (factory) setting is OFF. 1.

16Weather Forecast Icon Sensitivity Setting For locations with rapid changes of weather conditions, the weather icons can be set to a differen

176. Press and release the PLUS (+) or MINUS (-) button to set the alarm minute. 7. Press and release the “SET” button to confirm and exit the Alar

18Note: It will take a few seconds until the sun/moon data will be displayed. The display will return after 3 minutes to normal mode. The “CH” butt

19 WEATHER FORECASTING ICONS: Note: The weather forecast icons of this indoor weather station are a prediction of what the weather is going to do in

2 Topic Page Inventory of Contents/Additional Equipment 3 About WWVB 4 Quick Set-Up Guide 5 Detailed Set-Up Guide Battery Installation 6 Program

20indoor weather station will be more accurate compared to use in areas where the weather is stagnant most of the time (for example mostly sunny). I

21TOGGLING AND RESETTING THE OUTDOOR RECORDINGS: 1. To toggle between the outdoor current, maximum and minimum temperature data and the times they

22if this is not done correctly and if the total time for set-up exceeds 6 minutes. SET-UP OF MULTIPLE UNITS 1. It is necessary to remove the batt

23THE REMOTE TEMPERATURE SENSOR The remote temperature sensor can be mounted in two ways: • with the use of screws • using the adhesive tape

24THE INDOOR TEMPERATURE STATION The indoor temperature station can be mounted in two ways: • with the table stand • on the wall with the use of a w

25City Listing (In order as they appear on left side of unit) Montgomery, Alabama Little Rock, Arkansas Phoenix, Arizona Los Angeles, California Sa

26 Problem: No reception of WWVB time signal Solution: 1) Wait overnight for signal. 2) Be sure indoor weather station is at least 6 feet from any el

27MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vibration and shock should be avoided to prevent damage to the units. • Clean displays

28SPECIFICATIONS Temperature measuring range: Indoor: 32°F to 140°F with 0.1°F resolution. (0°C to 60°C with 0.1°C resolution) “OF” displayed if o

29WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and wo

3INVENTORY OF CONTENTS 1. The indoor weather station (Figure 1). 2. One TX6U remote temperature sensor with mounting bracket (Figure 2).

30PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH. This warranty gives you specific legal rights. You may also have o

WS-9016U Cities List Montgomery, Alabama Little Rock, Arkansas Phoenix, Arizona Los Angeles, California San Francisco, California Denver, Colorado Wa

4ABOUT WWVB (Radio Controlled Time) The NIST (National Institute of Standards and Technology—Time and Frequency Division) WWVB radio station is lo

5QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor weather station and remote temp

6DETAILED SET-UP GUIDE I. Battery Installation A. Remote Temperature Sensor 1. Remove the mounting bracket. The bracket snaps on and off easily

7II. Program Mode Programming Note: If 30 seconds are allowed to pass or either the IN or the OUT button is pressed during programming modes, the u

83. MINUS (-) button • Decrease value in all setting modes • Decrease the digits • Stop the alarm during alarm ringing 4. SUN/MOON button • En

9B. LCD Screen The LCD screen is split into 5 sections displaying the information for time and date, sun/moon data, indoor data, weather forecast an