La-crosse-technology WS-9029U User Manual download pdf (Page 5)

DETAILED SETUP GUIDE

I. BATTERY INSTALLATION (When one Temperature sensor is being used)

1. First, insert the batteries to the Temperature sensor (see “A. Temperature sensor” below).

2. Within 2 minutes of powering up the sensor, insert the batteries to the Weather Station (see

“B. Wireless Weather station” below). Once the batteries are in place, all segments of the

LCD will light up briefly. Following the indoor temperature and the time as 12:00 will be

displayed, and the signal reception icon will flash. If they are not shown in LCD after 60

seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once

the indoor data is displayed user may proceed to the next step.

3. After the batteries are inserted, the Weather Station will start receiving data signal from the

sensor. The outdoor temperature should then be displayed on the Weather Station. If this does

not happen after 2 minutes, the batteries will need to be removed from both units and reset

from step 1.

A. TEMPERATURE SENSOR

1. Remove the Battery Cover.

2. Observing the correct polarity, install 2 “AAA” Alkaline

Batteries—make sure they do not spring free, or start-up

problems may occur.

3.Replace the Battery Cover.

B. WIRELESS WEATHER STATION

Note: After the batteries are installed, DO NOT press any buttons. This may interfere with the

signals, causing temperatures to register incorrectly.

1. Remove the Battery Cover on the back of the Wireless Weather Station.

2. Observing the correct polarity, install 2 “AA” Alkaline Batteries.

3. Replace Battery Cover.

4. Wait 15 minutes before pressing any buttons.

Battery

Compartment

Battery

Cover

Remote

Temperature

Sensor (TX-25U)

Battery

Com

artment

Battery

Cove

Wireless Weather

Station

Sensor signal

reception icon*

1 2 3 4 5 6 7 8 9 10 11

No comments

La-crosse-technology WS-9029U User Manual Page 5