WS-7034U-IT Wireless 915 MHz Temperature Station Instruction Manual
10Resetting Min and Max Temperatures To reset both the minimum and maximum temperatures—press and hold the “RESET/+” button for 4 seconds. Adding A
11first into all the remote temperature sensors. Second install batteries into the indoor temperature station and do not press any buttons for ten m
12Remote Temperature Sensor 1. Remove the mounting bracket from the remote temperature sensor. 2. Mount the bracket in the desired location with
13temperature station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology v
14so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to eac
15is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vib
16Measuring Temperatures Indoor Temperature Station 14.1°F to 139.82°F with 0.2 °F resolution. (-9.9°C to 59.9°C with 0.1°C resolution). Remote Tem
17Dimensions: (L x W x H) Indoor Temperature Station 2.36 x .88 x 5.90 in. (excluding table stand) (60 x 22.5 x 150 mm). Remote Temperature Sensor
18of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center.
19Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused b
2TABLE OF CONTENTS Topic Page Quick Setup 3-5 Inventory of Contents 6 Detailed Setup Guide Battery Installation 7 Setting the Time 7-8 Selectin
20SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC IN
[email protected] (information on other products) web: www.lacrossetechnology.com FCC DISCLAIMER This device complies with part 15 of
22duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher. This handbook may contain
3QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor temperature station and remote temperat
4display will show both the indoor temperature and an outdoor temperature. If the indoor temperature station does not display both temperatures afte
5NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor temperature
6 ADDITIONAL EQUIPMENT (not included) 1. 1 Philips screwdriver. 2. 2 Fresh AAA Alkaline batteries. 3. 2 Fresh AA Alkaline batteries DET
7Battery Cover problems may occur. 2. Install 2 AAA batteries in the indoor temperature station. Do not press any buttons for at least ten minutes.
85. Press and release the “SET” button to move to the minute setting 6. Press and release the “MIN/MAX” button to set the minutes. 7. Press and relea
9FEATURES Minimum and Maximum Temperatures 1. Press and release the “MIN/MAX” button, “MIN” appears next to the indoor and remote temperatures. 2.
Comments to this Manuals